Tikkurila worldwide

Temalac SC 50

Tikkurila Industry 9L
描述 A high solids semigloss alkyd paint, containing anti-corrosive pigments.
产品特性 A semigloss 1-coat finish or topcoat to be used in alkyd systems for steel surfaces. When used as a 1-coat finish the substrate must be blast cleaned.
推荐用途 Recommended for steel framework, service platforms and different types of machinery and equipment.

色卡 RAL, NCS, SSG, BS, MONICOLOR NOVA and SYMPHONY colour cards. TEMASPEED tinting.
光泽组别 半光

Recommended film thicknesses

Theoretical coverage




80 µm

135 µm

7,4 m2/l

100 µm

170 µm

5,9 m2/l

Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
涂刷方法 By airless or conventional spray.

DFT 80 µm

+ 10 ºC

+ 23 ºC

+ 35 ºC

Dust dry, after

1 h

30 min

20 min

Touch dry, after

8 h

5 h

3 h

Recoatable, after

48 h

24 h

16 h

Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.
Solids volume 61 ± 2 volume % (ISO 3233)
76 ± 2 weight %
密度 1.5 kg / l depending on colour.
产品编号 571-series

施工条件 All surfaces must be dry. The temperature of the ambient air, surface or paint should not fall below + 5 ºC during application or drying. Relative humidity should not exceed 80 %. The surface temperature of the steel should remain at least 3 ºC above the dew point.
准备 Oil, grease, salts and dirt are removed by appropriate means. (ISO 12944-4)

Steel surfaces: Blast clean to grade Sa2½. (ISO 8501-1).

Primed surfaces: Oil, grease, salt and dirt are removed from the surface by appropriate means. Repair any damage to the primer coat. Note the overcoating time of primer. (ISO 12944-4)
喷面漆 TEMALAC SC 50.
涂刷 By airless or conventional spray. Mix the paint thoroughly before use. At airless spray application the paint should be thinned 0 - 5 % and at conventional spray application 5 - 10 %. Airless spray nozzle tip 0.011" - 0.015" and nozzle pressure 180 - 240 bar. Spray angle shall be chosen according to the shape of the object. In order to reach thicker coats use "wet-on-wet" technique.
工具清洗 Thinner 1006.
EU VOC 2004/42/EC-限值 The Volatile Organic Compounds amount is 360 g/litre of paint.
VOC content in ready to use paint (thinned 10 % by volume) is 410 g/l.

Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy.