Tikkurila worldwide

Temamastic PM 100

Tikkurila Industry 9L
描述 A two component, high solids, modified epoxy paint, aluminium pigmented.
产品特性 Can be used as a primer for steel surfaces exposed to mechanical and chemical stress and water immersion. May also be used as a single coat protection.
推荐用途 Recommended for different types of steelwork, machinery and equipment in the wood-processing and chemical industry, such as paper machines, conveyors, pumps etc.

特性 Due to aluminium pigmentation it forms a very tight, abrasion and chemical resistant coat. Low solvent content - lower solvent emissions than with traditional epoxy paints.
色彩类别 Greenish and reddish aluminium.
光泽组别 半光

Recommended film thicknesses

Theoretical coverage




50 µm

65 µm

16.0 m2/l

150 µm

190 µm

5.3 m2/l

Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
混合比例 Base 1 part by volume 008 7281-2
Hardener 1 part by volume 008 7289
涂刷方法 By airless spray or brush.
适用期 1 h

DFT 100 µm

+ 10 ºC

+ 23 ºC

+ 35 ºC

Dust dry, after

5 h

2½ h

1 h

Touch dry, after

9 h

5 h

2½ h

Recoatable without sanding, min/max. after

9 h - 5 d

5 h - 3 d

2½ h - 1 d

Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.
Solids volume 80 ± 2 volume % (ISO 3233)
84 ± 2 weight %
密度 1.3 kg / l (mixed)
产品编号 008 7281-2

施工条件 All surfaces must be dry. The temperature of the ambient air, surface or paint should not fall below +10 ºC during application and drying. Relative humidity should not exceed 80 %. The surface temperature of the steel should remain at least 3 ºC above the dew point.
准备 Oil, grease, salts and dirt are removed by appropriate means. (ISO 12944-4)

Steel surfaces: Blast clean to grade Sa2½. Clean small damages by tool cleaning to St2. (ISO 8501-1)

Earlier painted surfaces: Roughen old paint surfaces using e.g. abrasive wheel, sand paper or blast cleaning.
涂刷 By airless spray or brush. Depending on the temperature of the components the paint can be thinned 0 - 10 %. Airless spray nozzle tip 0.013" - 0.019" and nozzle pressure 120 - 180 bar. Spray angle shall be chosen according to the shape of the object. At brush application the paint should be thinned according to the circumstancies.
成分混合 First stir base and hardener separately. The correct proportions of base and hardener must be mixed thoroughly before use. Use Temaspeed Squirrel Mixer for mixing.
工具清洗 Thinner 1031.
EU VOC 2004/42/EC-限值 The Volatile Organic Compounds amount is 230 g/litre of paint.
VOC content of the paint mixture (thinned 10 % by volume) is 287 g/l.

Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy.