Temachlor 40
|
|
描述 |
One component high build paint, based on chlorinated rubber. |
产品特性 |
A finishing coat for chlorinated rubber systems. Recommended for surfaces exposed to marine or industrial climates and mild chemical attack. Can be used as a vapour barrier coating for concrete surfaces. VTT´s (Technical Research Centre of Finland) report available. |
推荐用途 |
Bridges, cranes, conveyors, harbour equipment and tank exteriors. |
|
技术参数 |
特性 |
High film build properties. Can be applied at low temperatures. Tolerates temperatures up to 80 ºC dry heat. |
色卡 |
RAL, NCS, SSG, BS, MONICOLOR NOVA and SYMPHONY colour cards. TEMASPEED tinting. |
光泽组别 |
半光 |
涂布率 |
Recommended film
thicknesses
|
Theoretical
coverage
|
dry
|
wet
|
|
50 µm
|
120 µm
|
8.4 m2/l
|
70
µm
|
170
µm
|
6.0
m2/l
|
Practical
coverage depends on the application method, painting conditions and the shape
and roughness of the surface to be coated.
|
涂刷方法 |
By airless
spray or brush. |
干燥时间 |
DFT 60 µm
|
+ 10 ºC
|
+ 23 ºC
|
+ 35 ºC
|
Dust dry, after
|
1 h
|
½ h
|
15 min
|
Touch dry, after
|
3 h
|
2 h
|
1 h
|
Recoatable, after
|
5 h
|
4 h
|
3 h
|
Drying
and recoating times are related to the film thickness, temperature, the
relative humidity of the air and ventilation. NB. Excessive film thickness
prolongs the drying time.
|
Solids volume |
42 ± 2 % volume (ISO 3233)
59 ± 2 % weight |
密度 |
1.2 - 1.3. kg / l depending on colour |
产品编号 |
140-series |
|
使用说明 |
施工条件 |
All surfaces must be dry. The temperature of the ambient air and surface should not fall below -10 ºC during application or drying. Relative humidity should not exceed 85 %. The surface temperature of the steel should remain at least 3 ºC above the dew point. |
准备 |
Primed surfaces: Oil, grease, salt and dirt are removed from the surface by appropriate means. Repair any damage to the primer coat. Note the overcoating time of primer. (ISO 12944-4) |
涂刷底漆 |
TEMANYL MS PRIMER, TEMASIL 90, TEMAZINC 77, TEMAZINC 88 and TEMAZINC 99. |
喷面漆 |
TEMACHLOR 40. |
涂刷 |
By airless spray or brush. Mix the paint thoroughly before use. Depending on the application method the paint can be thinned 0 - 10 %. Airless spray nozzle tip 0.013" - 0.019", spray angle shall be chosen according to the shape of the object. |
工具清洗 |
Thinner 1006 or Thinner 1053. |
EU VOC 2004/42/EC-限值 |
The Volatile Organic Compounds amount to 560 g/litre of paint.
VOC content of the paint (thinned 10 % by volume) is 595 g/l of paint. |
|
健康安全等级 |
|
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy.
For industrial use only. |
|
- |
|