Tikkurila worldwide

Temadur HF-Extra

Tikkurila Industry 9L
描述 A hammer finish additive.
产品特性 Used in TEMADUR and DUASOLID THL and TML base paints, TEMASPEED tinted or untinted, in order to reach a hammer finish.
推荐用途 Suitable e.g. for tools, engines and various equipment.

涂布率 Recommended amount to be added: 5 volume % to the paint/hardener mixture.
密度 0.9 kg / l
收缩和开裂 990 1265

处理 Base paints should be tinted before adding of TEMADUR HF-EXTRA. Mix thoroughly TEMADUR HF-EXTRA and the base paint, after that add the hardener and mix again thoroughly. Usually the application is done by conventional spray and unthinned paint. (Exceptionally the application can be done by brush or roller but in these cases the hammer effect is not the same as after spray application). To ensure that the hammer effect is as wanted begin with painting a smaller test area. If necessary, thin with Thinner 1048. It is recommended that the application should be done as "wet in wet" with a short interruption for solvent evaporation. Depending on the application method you will get a little different hammer finish for each.

It is recommended that the equipment is cleaned with thinner, which should be destroyed, immediately after application. If TEMADUR HF-EXTRA, paint mixture and cleaning thinner get in connection with other paints it may cause blistering.
EU VOC 2004/42/EC-限值 The Volatile Organic Compounds amount is 890 g/litre of paint.

The Volatile Organic Compounds amount is X g/litre of paint mixture.
VOC content of the paint mixture (thinned X % by volume) is X g/l.

Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy. For professional use only.