Tikkurila worldwide
产品使用说明书
03.01.2006

Temaprime ML

 
Tikkurila Industry 9L
描述 A fast drying, one component anti-corrosive pigmented alkyd primer.
产品特性 Primer in alkyd systems for steel surfaces exposed to weathering. Ideal for use in assembling plants and painting stations with rapid production cycles. Can also be used without any topcoat for steel surfaces in dry indoor areas.
推荐用途 Recommended for steel structures, agricultural, construction and other machinery.

技术参数
色彩类别 Grey (TVT 4001), red (TVT 4000) and yellow (TVT 4006).
光泽组别 哑光
涂布率

Recommended film thicknesses

Theoretical coverage

dry

wet

 

40 µm

80 µm

12.5 m2/l

60 µm

120 µm

8.3 m2/l


Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
涂刷方法 By airless or conventional spray or by brush.
干燥时间

DFT 50 µm

+ 10 ºC

+ 23 ºC

+ 35 ºC

Dust dry, after

40 min

20 min

10 min

Touch dry, after

1½ h

40 min

30 min

Recoatable, after

1½ h

40 min

30 min


Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.
Solids volume 50 ± 2 % volume (ISO 3233)
70 ± 2 % weight
密度 1.3 - 1.4 kg / l depending on colour
产品编号 189-series

使用说明
施工条件 All surfaces must be dry. The temperature of the ambient air, surface or paint should not fall below +5 ºC during application or drying. Relative humidity should not exceed 80 %. The surface temperature of the steel should remain at least 3 ºC above the dew point.
准备 Oil, grease, salts and dirt are removed by appropriate means. (ISO 12944-4)

Steel surfaces: Blast clean to grade Sa2½. (ISO 8501-1) If blast cleaning is not possible, phosphating is recommended for cold rolled steel to improve adhesion.

Primed surfaces: Oil, grease, salt and dirt are removed from the surface by appropriate means. Repair any damage to the primer coat. Note the overcoating time of primer. (ISO 12944-4)
涂刷底漆 TEMAPRIME ML.
喷面漆 TEMALAC, FONTECRYL and FONTELAC.
涂刷 By airless or conventional spray or by brush. Mix the paint thoroughly before use. The paint can be thinned 0 - 15 % at airless spray application and 20 - 30 % at conventional spray application. Airless spray nozzle tip 0.011" - 0.015" and nozzle pressure 120 - 180 bar. Spray angle shall be chosen according to the shape of the object. For large surfaces use Thinner 1053 (slow).
工具清洗 Thinner 1006.
EU VOC 2004/42/EC-限值 The Volatile Organic Compounds amount is 450 g/litre of paint.
VOC content of the paint (thinned 30 % by volume) is 545 g/l.

健康安全等级
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy.
 
-


返回