Temazinc EE
|
|
描述 |
A one component zinc dust paint. |
产品特性 |
Used as a primer for steel surfaces exposed to weathering and chemical stress. Ideal as a touch-up primer on damaged areas of zinc primed steel. Can be used without a topcoat on surfaces exposed to climatic stress. |
推荐用途 |
Steel surfaces. |
|
技术参数 |
特性 |
Offers cathodic protection for steel. |
色彩类别 |
Grey. |
光泽组别 |
哑光 |
涂布率 |
Recommended film
thicknesses
|
Theoretical
coverage
|
dry
|
wet
|
|
30 µm
|
55 µm
|
18.2 m2/l
|
50
µm
|
90
µm
|
11.1
m2/l
|
Practical
coverage depends on the application method, painting conditions and the shape
and roughness of the surface to be coated.
|
涂刷方法 |
By dipping,
spray or brush. |
干燥时间 |
DFT 40 µm
|
+ 10 ºC
|
+ 23 ºC
|
+ 35 ºC
|
Dust dry, after
|
30 min
|
15 min
|
15 min
|
Touch dry, after
|
3 h
|
1,5 h
|
1 h
|
Recoatable, after
|
12 h
|
6 h
|
3 h
|
Drying
and recoating times are related to the film thickness, temperature, the
relative humidity of the air and ventilation.
|
Solids volume |
56 ± 2 % volume |
密度 |
2.7 kg / l |
产品编号 |
008 7395 |
|
使用说明 |
施工条件 |
All surfaces must be dry. The temperature of the ambient air or surface should not fall below + 5 ºC during application and drying. Relative humidity should not exceed 80 %. The surface temperature of the steel should remain at least 3 ºC above the dew point. |
准备 |
Oil, grease, salts and dirt are removed by appropriate means. (ISO 12944-4)
Steel surfaces: Blast clean to grade Sa2½. (ISO 8501-1) |
喷面漆 |
TEMANYL MS PRIMER, TEMAPRIME EE and FONTECRYL 10. |
涂刷 |
By dipping, spray or brush. Mix the paint thoroughly before use. Depending on the application method the paint should be thinned 0 - 10 % by volume. Airless spray nozzle tip 0.015" - 0.021" and nozzle pressure 120 - 180 bar. Spray angle shall be chosen according to the shape of the object. |
工具清洗 |
Thinner 1006. |
EU VOC 2004/42/EC-限值 |
The Volatile Organic Compounds amount is 385 g/litre of paint.
VOC content of the paint (thinned 10 % by volume) is 417 g/l. |
|
健康安全等级 |
|
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets.
A health and safety data sheet is available on request from Tikkurila Oy. |
|
- |
|