Tikkurila worldwide
产品使用说明书
29.12.2005

Fontecryl PP

 
Tikkurila Industry 9L
描述 A waterborne, one component fast drying acrylic based primer containing active anticorrosive pigments.
产品特性 Recommended e.g. as an anti-corrosive primer under powder coatings on steel. Especially suitable for dipping. Drying times can be shortened by using higher temperatures. Overcoatable with a wide range of products, also with solventborne products.
推荐用途 Steel surfaces.

技术参数
色彩类别 Grey and yellow.
光泽组别 哑光
涂布率

Recommended film thicknesses

Theoretical coverage

dry

wet

 

15 µm

30 µm

32.0 m2/l

30 µm

65 µm

16.0 m2/l


Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
稀释剂
涂刷方法 By dip or conventional spray.
干燥时间

DFT 30 µm

+ 23 ºC

Dust dry, after

20 min

Touch dry, after

30 min

Through dry, after

24 h

Recoatable with powder coatings, after

Note! Before overcoating all the solvents and water have to be evaporated from the primer.

20 - 30 min

Through dry at increased temperatures after 15 min / 60 ºC


Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.
Solids volume 48 ± 2 % volume
密度 1.2 - 1.3 kg / l
产品编号 006 5980 and 006 5981

使用说明
施工条件 All surfaces must be dry. The temperature of the ambient air, surface or paint should not fall below +15 ºC during application or drying. Relative humidity should be between 20 - 70 %. The surface temperature of the steel should remain at least 3 ºC above the dew point.
准备 Oil, grease, salts and dirt are removed by appropriate means. (ISO 12944-4)

Steel surfaces: Blast clean to grade Sa2½. (ISO 8501-1) If blast cleaning is not possible, phosphating is recommended for cold rolled steel to improve adhesion.
涂刷底漆 FONTECRYL PP.
喷面漆 FONTECRYL 25, FONTECRYL 50 and powder coatings.
涂刷 By dip or conventional spray. Depending on the application method the paint can be thinned 0 - 10 %. At dipping the viscosity should be 15 - 20 s DIN 4 and at conventional spray application 20 - 30 s DIN 4. Before overcoating all the solvents and water have to be evaporated from the primer.

Note! The viscosity falls quickly when thinning the paint.
工具清洗 FONTECLEAN 1921.
EU VOC 2004/42/EC-限值 The Volatile Organic Compounds amount is 40 g/litre of paint.
VOC content of paint (thinned 10 % by volume) is 35 g/l.

健康安全等级
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy. For professional use only.
 
-


返回