Fontedur 90

产品使用说明书
28.03.2006

Fontedur 90

描述

A waterborne, two component polyurethane finish.

产品特性

Suitable to be used as a glossy topcoat for steel surfaces in epoxy and polyurethane systems.

推荐用途

Steel surfaces.

技术参数

特性

Resistant against moderate mechanical and chemical stress. Good gloss and colour retention in climatic stress.

色卡

TEMASPEED FONTE tinting.

光泽组别

光

涂布率

Recommended film thicknesses		Theoretical coverage
dry	wet
40 µm	80 µm	12.5 m²/l

Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.

稀释剂

水

混合比例

Base 5 part by volume 145-series
Hardener 1 part by volume 007 1600

涂刷方法

By conventional or airless spray or by brush.

适用期

1½ h

干燥时间

DFT 40 µm	+ 15 ºC	+ 23 ºC	+ 50 ºC
Dust dry, after	3 h	1½ h	20 min
Touch dry, after	12 h	6 h	2 h
Recoatable, after	16 h	8 h	3 h
Fully cured, after	14 d	7 d	3 d

Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.

Solids volume

50 ± 2 volume % (ISO 3233)
62 ± 2 weight %

密度

1.3 ± 0.1 kg / l (mixed)

产品编号

145-series

使用说明

施工条件

All surfaces must be dry. The temperature of the ambient air, surface or paint should not fall below +15 ºC during application or drying. Relative humidity should not exceed 80 %. The surface temperature of the steel should remain at least 3 ºC above the dew point.

准备

Primed surfaces: Oil, grease, salt and dirt are removed from the surface by appropriate means. Repair any damage to the primer coat. Note the overcoating time of primer. (ISO 12944-4)

涂刷底漆

FONTECOAT EP PRIMER, FONTECOAT EP 50, FONTECRYL 10, FONTECRYL AP and TEMACOAT GPL-S PRIMER.

喷面漆

FONTEDUR 90 and TEMADUR CLEAR.

涂刷

By conventional or airless spray or by brush. The paint should be thinned 10 - 20 % after mixing. Components may not be thinned before mixing. Airless spray nozzle tip 0.011" - 0.013" and nozzle pressure 120 - 180 bar. Spray angle shall be chosen according to the shape of the object.

成分混合

First stir base and hardener separately. The correct proportions of base and hardener must be mixed very thoroughly before use. Use Temaspeed Squarrel Mixer for mixing.

工具清洗

Water or FONTECLEAN 1921. The equipment must be cleaned immediately after use before the paint dries.

EU VOC 2004/42/EC-限值

The Volatile Organic Compounds amount is 85 g/litre of paint.
VOC content of paint (thinned 20 % by volume) is 70 g/l.

健康安全等级

Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy. For professional use only.

上述信息，基于实验室测试和实际应用而获得，产品使用说明书记载了其被验证有效的日期，我们的生产体系通过了ISO9001和ISO14001认证，可充分保证该产品的质量。对不按使用说明施工和产品用于不当场合所带来的任何损失，作为生产商，我们不会承担任何责任。