Tikkurila worldwide
产品使用说明书
27.04.2007

Fontedur HB 80

 
Tikkurila Industry 9L
描述 A two component, waterborne polyurethane topcoat.
产品特性 Suitable for steel surfaces exposed to weathering, abrasion and chemical stress.
推荐用途 Steel surfaces.

技术参数
特性 Good gloss retention in climatic stress. Can be cured at higher temperatures. For industrial use only according to Directive 1999/13/EC.
色卡 RAL, NCS, SSG, BS, MONICOLOR NOVA and SYMPHONY colour cards. TEMASPEED FONTE tinting.
光泽组别
涂布率

Recommended film thicknesses

Theoretical coverage

dry

wet

 

40 µm

90 µm

11.2 m2/l

50 µm

110 µm

9.0 m2/l


Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.
稀释剂
混合比例 Base 2.5 parts by volume 156-series
Hardener 1 part by volume 008 7605
涂刷方法 By airless or conventional spray.
适用期 1 h
干燥时间

DFT 40 µm

+ 15 ºC

+ 23 ºC

+ 60 ºC

Dust dry, after

6 h

1 h

45 min

Touch dry, after

8 h

2  h

1 h

Recoatable , min. after

24 h

2 h

1 h


Drying and recoating times are related to the film thickness, temperature, the relative humidity of the air and ventilation.
Solids volume 45 ± 2 volume %
60 ± 2 weight %
密度 Approx. 1.3 kg / l mixture
产品编号 156-series

使用说明
施工条件 Primed surfaces: Oil, grease, salt and dirt are removed from the surface by appropriate means. Repair any damage to the primer coat. Note the overcoating time of primer. (ISO 12944-4)
准备 All surfaces must be dry. The temperature of the ambient air, surface or paint should not fall below +15 ºC during application or drying. Relative humidity should not exceed 80 %. The surface temperature of the steel should remain at least 3 ºC above the dew point.
涂刷底漆 FONTECOAT EP PRIMER, FONTECRYL 10 and FONTECRYL AP.
喷面漆 FONTEDUR HB 80.
涂刷 By airless or conventional spray. Depending on the application method the paint can be thinned 0 - 10 %. At airless spray application the paint should be thinned max. 5 % with water, nozzle tip 0.011" - 0.013". Spray angle shall be chosen according to the shape of the object. At conventional spray application the viscosity should be 18 - 22 s DIN 4.
成分混合 First stir base and hardener separately. The correct proportions of base and hardener must be mixed thoroughly before use. Use Temaspeed Squirrel Mixer for mixing.
工具清洗 Mixed and dried paint with Thinner 1126. If the hardener is still wet use Thinner 1127.
EU VOC 2004/42/EC-限值 The Volatile Organic Compounds amount is 155 g/litre of paint.
VOC content in paint (mixed 10 % of water) is 145 g/litre of paint.

健康安全等级
Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy.
 
-


返回