Tikkurila worldwide

Luminol Extra 25, 55

Tikkurila Industry 9L
描述 UV-curing, water-borne lacquer.
产品特性 Wooden surfaces indoors. Good resistance to abrasion and chemicals.
推荐用途 Recommended for furniture, doors of kitchen fittings and other wooden surfaces.

色彩类别 Colourless.
光泽组别 半哑光 和 半光
排放等级 The lacquer does not contain free formaldehyde and after drying it does not emit formaldehyde to the environment.

4 - 5 m2/l (100 μm).

Practical coverage depends on the application method, painting conditions and the shape and roughness of the surface to be coated.

Application technique

Application viscosity DIN4

Low pressure spraying

30 - 40 s

Airmix or airless spraying

35 - 50 s

Curtain coating

50 - 70 s

干燥时间 (60 - 100 g/m2)

Dry to stack immediately after UV-curing.

Water should be allowed to flash off before UV-curing. Flash-off time depends on the temperature and the amount and the speed of the air.

Required UV-energy: 600 mJ/cm2 (New American Calibration).
Solids volume abt. 33 % by volume, 35 % by weight.
密度 1.0 kg/litre
产品编号 900 3032 and 900 3033

施工条件 The surface to be treated has to be clean and dry. During application and drying the temperature of the air, the surface to be treated and the lacquer has to be over 18 ºC and the relative humidity of the air below 70 %.
喷面漆清漆 Stir the lacquer carefully before use. Thin with water to the viscosity required, if necessary.
工具清洗 Water.
EU VOC 2004/42/EC-限值 The Volatile Organic Compounds amount is 65 g/litre of lacquer.
Maximum VOC content in ready to use lacquer (thinned 10 % by volume) is 65 g/l.

Containers are provided with safety labels, which should be observed. Further information about hazardous influences and protection are detailed in individual health and safety data sheets. A health and safety data sheet is available on request from Tikkurila Oy.